Quote:
According to Ron DeLong 9999 is the expected preferred reading and they work to achieve that in cases where needed. I appreciate your info, just trying to understand how a few various cars are different than most. |
I only see 9999 in instant mpg mode for a very brief time right after I bump-start the engine at the end of the glide. While it is gliding, I see what appears to be the speed x* readout. Current trip mode just shows accumulating mileage as usual.
|
Quote:
Have you talked with DeLong about your SG? What does he say? |
Quote:
|
Now if I just had hills big enough to do this on, our hills are very gradual around here. Enough to suck up gas going up, but barely enough to glide down and see much of a difference...........:( I have ONE hill that I can drift down .7 of a mile IF no one is behind me because at the end I am at a crawl - again, very gradual. That being said, I do live in the highest point of Florida - yep, the Florida mountains. :p
|
Quote:
I retract my suggestion of firing up the engine on test 1, a matched terminal speed if only examining the downhill legs is a sufficient reference point. The fact that it went 3.6 miles farther is significant. The fact that the second test averaged 20mph faster is also significant. The fact that it was on top of a mountain is also significant ;) I don't know that we learned enough to make a mpg comparison though (didn't actually use any fuel). CO, I'd love to get your mileage ratings. You have to cover a lot of ground out there so it's especially awesome that you are making those kind of numbers. |
Quote:
|
diamondlarry -
Quote:
I think this is a question for the ScanGauge guy. Also, why not go to 0.01 GPH? Is this just a display thing where we ScanGauge only wants to express x.x digits? Question : Would switching to metric units for ScanGauge usage yield better accuracy in the ScanGauge because the liter as a unit is smaller? Todo List : 1.00 Gallons equals 3.79 Liters. Therefore, 0.1 Gallons equals 0.379 liters. This would imply that for the "0.1 GPH" scenario, the ScanGauge should display "0.4 LPH" (assuming roundup). However, IF the ScanGauge displays 0.1 LPH (a failsafe value for a different unit), then the "KPG" calculation would be more accurate for engine-off strategy. This would imply the need, for accuracy, to use the ScanGauge in "liter display" mode and convert as needed, :mad: . CarloSW2 |
I will give the Metric thing a try today. I'll also see if you can switch back and forth without having to convert back to gallons.
|
I'm in Daytona. FE is pretty important here sometimes, especially with 1 or 2 laps to go. No coasting here till you're out of gas.
|
All times are GMT -8. The time now is 07:05 PM. |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2025, vBulletin Solutions, Inc.