Re: My Honda CBF125 on 150mpg :)
6 Attachment(s)
Hi Daniel, Congratulations on your excellent fuel economy, very impressive. How fast is your CBF 125? Can it go 80 mph? Here in the USA a motorcycle must have at 15 bhp to be allowed on the freeways. Its too bad that Homda and the other major motorcycle manufacturers don't sell fuel-injected small displacement bikes like in Europe .
As far as better fuel economy , ride smooth, corner hard, avoid braking, coast when you can and use low RPMs to accelerate and cruise. You could change your chain drive sprockets to reduce RPMs if your bike has enough torque. Keep your tire pressures up. Consider more aerodymanic streamlining like I'm working on. Check out the Craig Vetter website and his work on the Freedom Machine. All the best , L&S |
Re: My Honda CBF125 on 150mpg :)
Quote:
Anyway, I don't think I can advise you wouldn't already know. Pulse&glide, maybe? I often do that, especially when not in top gear, but I don't know if it's of any use with such a small bike, in top gear. It's less useful even on our 250 than on the 650. At (low) highway speeds, at least. But you seem to move in a very different range. It may work, who knows. |
Re: My Honda CBF125 on 150mpg :)
Nop, its not modified! This tank is 13L, but it has a little neck up, it can reach almost 16L easily. From factory the 13L are well measured, because they say to fill up until reach the "neck" ;)
thanks guys, i will try an other technic: going up hill with more throttle but lower rpm ;) |
Re: My Honda CBF125 on 150mpg :)
2 liters
first 37km WOT with another passenger 10km with 2 passengers, normal riding Total: 129.8km 1.54L each 100km - 152.74mpg I think works fine the more throttle & lowers RPM's, up hill ;) |
Re: My Honda CBF125 on 150mpg :)
Quote:
(Teresa's gearing is quite different, I can't shift into 5th under 70km/h and 4th under ~50. It's a lot of P&G for me in town. She's just too strong not to P&G.) One little thing you should try: use like 80% throttle instead of WOT, under 100% load BSFC diagrams tend to show worse efficiency again. |
Re: My Honda CBF125 on 150mpg :)
The first 40km was the top of "screw the consumptions" :D :D :D
The last 80km was the really economical driving :) What you mean by BSFC? thanks! |
Re: My Honda CBF125 on 150mpg :)
BSFC is Brake Specific Fuel Consumption. It's a way to measure engine efficiency (fuel used per energy produced; how efficiently it turns fuel into energy; not the same as vehicle fuel economy but certainly an important part).
Generally, modern car engines make energy most efficiently (low BSFC) when almost fully loaded. Wider throttle and lower RPM reduce pumping and reciprocating loss. I don't know if it applies directly to carbureted motorcycle engines. You can google for BSFC and read more about it or look at BSFC maps. |
Re: My Honda CBF125 on 150mpg :)
I don't know about the modern Honda singles, but the 1970's era single cylinder Hondas I've worked on (75cc, 100cc and 125cc) all had a sliding tube that served as the throttle valve in the carb. It was directly operated by the twist grip throttle. Connected to the sliding tube was a tapered metering rod that richened the mix as you moved closer to wide open throttle. The twin cylinder motorcycles that I've owned used a butterfly throttle valve and the metering rod that richened the mix was operated by a vacuum diaphragm- probably based on venturi vacuum (airflow).
My point is that if this bike has the metering rod directly controlled by the throttle position (twist grip throttle), upshfting early and using WOT/low rpm to climb hills may end up using more fuel because the engine is running really rich. If this bike has a vacuum operated metering rod, then WOT at low rpm will likely be a good strategy. If you look closely at the carb, you can tell the difference easily. If the throttle cable comes straight out of the top of the carb (opposite the float bowl), it is a tube type throttle valve with integrated metering rod. |
Re: My Honda CBF125 on 150mpg :)
I think the modern CBF is fuel injected, at least it surely is in Europe (Daniel wrote he lives in Portugal), just like their CBR125 which I had been eyeing with before buying Teresa.
That bike should be pretty similar to the CBF in terms of fuel efficiency. I almost regret that I didn't get one, but given that I rarely ride in town, I probably couldn't get the same average - by far. For lower speeds, and especially 1-up use on shorter distances I'd surely choose a small displacment bike like this. |
Re: My Honda CBF125 on 150mpg :)
Yes, like alvaro said, this CBF125 is fuel injected, it has a PGM-FI.
Yes, i searched for BSFC, learned something today, but there is nothing about this bike :\ Anyway, with the power courve, is anything good to know about the best RPM to ride? https://www.motorcycleraceparts.co.uk...5%2009%20-.jpg Today did 35.55km with 0.5L, it is 1.406 liters for each 100km, or 167MPG :) |
All times are GMT -8. The time now is 01:02 PM. |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2025, vBulletin Solutions, Inc.