Intake Air Temp resistor experiment.

[usedgeo]

Please don't overlook the post where I said that the results were all instrument error. I guess you haven't. I have ordered an LC1 wide band O2 sensor and controller but have not installed them yet.

http://www.innovatemotorsports.com/products/lc1.php

At true high intake temperature, above 180 F, the car appears to miss a bit during light acceleration. It still indicates closed loop so I do not have that completely explained yet. In any case the mileage is pretty good feeding the engine hot air. The plugs are pretty white but the slight miss could be from lots of EGR rather than a lean mixture. I expect the Somender gooves will have an effect on that miss and loss of torque. That project starts tomorrow .

68 ohms blue grey black gold. Two resistors in series for 136

470 ohms yellow violet brown gold. Two resistors in series for 940

Originally Posted by wireless0ne

can you give us the stripe configuration for the different resistances you used?

940 ohm
136 ohm=2 x 68 ohm