Some glue that won't melt when it gets hot?

[SVOboy]

I had my MID mounted by gluing the hell out of some velcro strips to is and then velcro to the dash/windsheild, which worked very well.

However, while I was on vacation is got pretty hot and as a result all the hot glue melted off the mid and it fell out of it's hole.

Is there anything I got use to attach the velcro that'll be a bit more permanent?

[Gary Palmer]

SVOboy: You should try using a polyurethane based glue. An expensive example is Gorilla glue. They make a "geneic" that's available at Home Depot, that work's just as well, as far as I can tell. The glue "set's up" from a chemical reaction with the humidity. It expands a little bit when it's setting up, but once it's stuck, it is flexible, but it won't come off. I have a piece of wood I glued to a cinder block fence about 10 years ago and the board is still there, even though the gate bang's on it every time someone goes in and out of the front yard. Be wise and use rubber glove's, though, it does not wash off and it takes day's for it to wear off.

[SVOboy]

Thanks for the tip, I'll check it out!

[GasSavers_DaX]

Liquid nails that b!tch.

[Gary Palmer]

You are cruel and harsh man!

[SVOboy]

We don't like him very much.

[krousdb]

I like him.

[GasSavers_DaX]

Originally Posted by krousdb

I like him.

Whoever him is must like being liked by a liker like you.

I still say use liquid nails.

[krousdb]

Originally Posted by DaX

Whoever him is must like being liked by a liker like you.

I still say use liquid nails.

The liker likes the likee due to like opinionisms on certain subjects. But on this one we must agree to disagree. I'll stick with velcro or duct tape due to it's lack of permanantumness.

And just for good measure, I suck.

[SVOboy]

Me too.