Click here to see important news regarding the aCar App

Honda Sabre Note Log

1984 Honda VF700S
Property of rem83. Added Sep 26 2008

Showing all notes


Nov 9 2012

Removed carbs, found one front and one rear cylinder had jets reversed. Put them back in the correct place and reinstalled. Changed headlight level to point down more.

  • 29,500

Added by rem83 on Nov 10 2012 at 8:32 am


Sep 2 2012

Set valve clearances Checked carb sync. Seemed to be good, so did not adjust throttle linkage. Swapped cylinder 2-4 coil.

Added by rem83 on Sep 10 2012 at 5:03 am


May 27 2012

Swapped original (cleaned and bench synced) carbs back onto bike. Replaced front cylinder head coolant crossover tube o-rings.

  • 29,527

Added by rem83 on May 29 2012 at 1:26 am


May 13 2012

Replaced pulse generator Replaced clutch with EBC friction discs, "de-glazed" steel discs with 200 grit Oil Change, 10w40, non-synthetic (no filter change)

  • 29,500

Added by rem83 on May 14 2012 at 6:38 am


Mar 30 2012

Re-soldered cylinder 2/4 spark box

  • 29,456

Added by rem83 on Mar 31 2012 at 8:00 am


Apr 26 2011

Changed Oil, 20w40 / 20w50 mix Mobil 1 Synthetic Motorcycle Oil, Fram motorcycle filter Replaced clutch basket / tensioned split gear springs Heli-coiled oil pan drain plug threads, changed to M12x1.75, replaced drain plug with autozone plug with rubber seal Replaced drain pan gasket Replaced exhaust collector with a freshly painted unit (por 15 black velvet) Reinstalled factory mufflers with new gaskets

Added by rem83 on Apr 27 2011 at 5:45 am


Dec 26 2010

Changed front coil, bike seems to be running better, didn't die at all during 20 mile test run

Added by rem83 on Dec 27 2010 at 5:49 am


Nov 6 2010

Replaced slow jets (#40) and set all float heights at ~8.3mm, lubricated throttle and choke linkages while carbs were out. Replaced speedometer cable with a new unit.

Added by rem83 on Nov 8 2010 at 5:56 am


Oct 11 2010

Replaced all 4 camshafts with a used set in good condition, as well as 7 rocker arms. Could not replace cylinder 4 rocker arm without removing the engine or cylinder head from the bike (frame interference) but it was in relatively good condition. Flushed the radiator while it was off, and replaced the fuse block with an un-modified fuse block. Bike seems to run but may need additional carb work.

Added by rem83 on Oct 12 2010 at 2:58 am


Jul 27 2010

Replaced tires with Avon AM26 both front and back. Greased the rear drive spline and replaced the rear brake pads. Tightened either the steering stem nut or jamb nut

  • 28,400

Added by rem83 on Aug 3 2010 at 7:02 am


Aug 31 2009

Changed over to '99 Sportster mufflers. Custom mounting brackets

  • 27,700

Added by rem83 on Sep 16 2009 at 2:04 am


May 24 2009

Replaced rear differential fluid with standard 80w90 hypoid gear oil. Re-used drain plug washer.

  • 27,510

Added by rem83 on May 25 2009 at 9:59 am


May 21 2009

Rebuilt clutch hydraulics (MC and SC), flushed / bled clutch hydraulics Flushed / bled brake hydraulics

  • 27,300

Added by rem83 on May 22 2009 at 1:46 am


Nov 19 2008

Replaced Spark Plugs Replaced Oil Filter / Oil Installed Oil Mod Kit Cleaned / Rebuilt Carbs Set Valve Clearances to 0.005" Replaced Air Filter Minor Engine Dressup / Cleaning / Gasket changes, including coolant tubes, alternator cover and valve covers

  • 27,050

Added by rem83 on Nov 20 2008 at 1:18 am


Nov 11 2008

Vehicle has been disassembled since September for the following: Carb Clean / Rebuild Set Valve Clearances Replaced Coolant Tube O-rings Installed DRP Oil Mod

Added by rem83 on Nov 12 2008 at 1:41 am


[Back to Vehicle Profile]

Tips

Engine Load, not RPM's save gas

Despite claims that RPM's are directly tied to fuel economy,... ...

by outlaw240

Read more tips