'88 Cirrusblau 635csi 5speed Note Log
1988 BMW 635CSi
Property of rem83.
Added Aug 30 2009
Showing all notes
Dec 12 2014
Oil change. 5 quarts of Mobil 1 15 w50, Mann oil filter
-
173,958
Added by rem83 on Dec 12 2014 at 7:16 pm
Dec 2 2013
Re-built clutch slave cylinder and vacuum bled Messed with driver side door lock cylinder - had reinstalled incorrectly at some point.
-
173,000
Added by rem83 on Dec 3 2013 at 11:37 pm
Oct 30 2013
Replaced brake master cylinder, both front brake hoses and rear passenger side outboard brake hose. Driver side and passenger side inboard rear brake hoses all have stuck fittings. Fully flushed and bled system
-
173,000
Added by rem83 on Oct 31 2013 at 2:54 am
Aug 24 2013
Changed v belts, Goodyear alternator and a/c, duralast power steering. Cleaned alternator. Need new alternator brushes and woodruff key.
-
172,761
Added by rem83 on Aug 25 2013 at 5:00 am
Oct 9 2012
Replaced front strut mounts, bump stops and dust shields, spring seat rubber, shocks (temporarily with Gabriel Ultras... Bilstein HDs on backorder). Replaced passenger side tie-rod boots with urethane boots. Replaced driveshaft center-bearing forward facing dust shield and fit Meistersatz center bearing and hanger (cut away excess rubber preventing dust shield from spinning freely).
-
171,000
Added by rem83 on Oct 10 2012 at 3:53 am
Jul 21 2012
Replaced fuel hoses going to and from the fuel rail. Replaced vacuum line to FPR. Old line was unhooked. Replaced distributor cap and rotor. Oil Change, 5.5 qts of Castrol 10w40 full synthetic, Mann filter
-
171,780
Added by rem83 on Jul 22 2012 at 3:29 pm
Jun 29 2012
Fuel filter change. New Mann filter and inlet and outlet 5\16 bulk fuel house
-
171,766
Added by rem83 on Jun 30 2012 at 4:06 am
May 19 2012
Replaced drive shaft, used unit with new uro parts csb. Re used flex disc Replaced rear subframe bushings
-
171,723
Added by rem83 on May 21 2012 at 12:36 pm
Jan 1 2012
Replaced rear sway bar end-links Replaced middle exhaust hangars Replaced afm to tb intake tube Added one can of refrigerant Replaced suction line going to compressor and added a heat shield
-
171,408
Added by rem83 on Jan 2 2012 at 4:31 am
Oct 14 2010
Replaced driveshaft center support bearing / hangar, driveshaft centering bushing, driveshaft clamping sleeve and shift console front bushing. The driveshaft was assembled approximately 100 degrees off when I removed it from the car. I reassembled the driveshaft with the u-joint yokes correctly aligned, but there is still noise under very high load at low speeds, so I suspect the driveshaft may need to be rebuilt.
Added by rem83 on Oct 15 2010 at 7:36 am
Jun 8 2010
managed to replace the last 2 stubborn plugs with platinum +4s. Engine revs smoothly now, regardless of load, throttle input or rpm range. Hopefully this will help the mpg a little! other recent fixes include: -replaced the diff mount -welded on the nose -welded on the mwrench steering fix -replaced transmission fluid with redline mtl -replaced diff fluid with 75w90 gl-5 redline hypoid gear oil -replaced lower control arm bushings -replaced idler arm bushing -replaced (missing) exhaust support pipe clamp -replaced a/c drier
Added by rem83 on Jun 9 2010 at 5:45 am
Aug 30 2009
Rebuilt odometer with new gears Replaced ICV Installed mwrench steering bracket fix (bracket was broken, with home-made fix on)
-
168,886
Added by rem83 on Aug 31 2009 at 2:21 am
[Back to Vehicle Profile]
